DISPLOY - SAMSUNG TV PLAYER
Installation guide


WHAT YOU NEED
-------------
  - A Windows PC
  - A Samsung Tizen TV (2018 model or newer)
  - Both on the SAME network (same router / same Wi-Fi)


STEP 1 - TURN ON DEVELOPER MODE (on the TV)
-------------------------------------------
  1. Press HOME and open APPS
  2. Press 1 2 3 4 5 on the remote - a small box appears
  3. Set "Developer mode" to ON
  4. Type the IP address of the WINDOWS PC you will install from
  5. Press OK, then TURN THE TV OFF AND ON AGAIN

  To find the PC's IP address: press Windows key + R, type cmd,
  press Enter, type ipconfig and press Enter. Use the
  "IPv4 Address" (it looks like 192.168.1.20).


STEP 2 - FIND THE TV'S IP ADDRESS
----------------------------------
  On the TV: Settings > General > Network > Network Status >
  IP Settings. Write down the IP address.


STEP 3 - INSTALL
-----------------
  1. Unzip this folder somewhere simple, e.g. C:\Disploy
     (Keep all the files together - do not move them apart.)
  2. Double-click install.bat
  3. Type the TV's IP address when asked, press Enter
  4. Wait. Copying takes about a minute on most networks.

  When it finishes, the TV shows a PAIRING CODE.


STEP 4 - PAIR THE SCREEN
-------------------------
  Enter the pairing code shown on the TV into the Disploy CMS.
  The TV will start playing its assigned content within a few
  seconds.


IF SOMETHING GOES WRONG
------------------------
  Press 1 1 1 on the TV remote - three times, quickly.

  A small message appears saying the report was sent. This
  sends the support team the TV model, the app version, and
  the last 10 minutes of activity, plus a picture of what was
  on screen. Nothing else is collected.

  You can press it any time the screen is not behaving.


COMMON PROBLEMS
----------------
  "The TV did not accept the connection"
     - Developer mode is off, or has the wrong PC IP in it
     - The TV was not restarted after turning it on
     - The TV and PC are on different networks
       (guest Wi-Fi is a common cause)

  The TV shows a pairing code again later
     - The screen was deleted in the CMS. Pair it again.

  Screen is black
     - Check the content schedule / operating hours in the CMS.
       Outside its scheduled hours the screen is meant to be dark.


UPDATING LATER
---------------
  Run install.bat again with a newer copy of this folder.
  It replaces the old version. Pairing is kept.
